Cold storage manufacturers: should pay attention to several aspects when installing cold storage
Cold storage installation is the most important part of the project. The preparation work in the early stage mainly includes the selection of cold storage location, the design of cold storage construction, the selection of cold storage equipment, and the setting of cold storage temperature. The next step is the cold storage installation. The cold storage manufacturer Ruixue reminds you that you should pay attention to several aspects when installing the cold storage:
1. The cold storage installation should be in a strong and stable place. Combined cold storage installation requires a horizontal concrete pedestal. When the base is tilted, the base must be repaired and flattened when it is uneven.
2. The cold storage installation plate is a steel frame lightweight prefabricated insulation board assembly structure, and the combined plate type cold storage is a single layer form. The load-bearing members are mostly made of thin-walled steel. The inner and outer panels of the slab are made of colored steel plates (the base material is galvanized steel), and the core material of the slab is foamed rigid polyurethane or affixed with polystyrene foam board. Since all the components are prefabricated according to the standard (Standard) in the professional factory and assembled on site, the construction progress is fast and the construction period is short.
3. The cold storage is installed in a place with good ventilation and low humidity. After the installation is completed, condensation may sometimes appear before the concrete base is dry. When the humidity is abnormally high in the rainy season, condensation will appear on the seams of the board. In the case of small, the condensation will also appear on the repair board. These are temporary phenomena and should be wiped when necessary.
4. In addition to the maximum thermal load of the warehouse, the cooling capacity must also take into account the possible failure of the installation and future maintenance.
5, cold storage drainage. The drainage in the reservoir is drained by a drain pipe. Water is often discharged, so the drainage should be directed to a place where it can flow smoothly. During the installation of the cold storage, the U-shaped pipe must be installed on the drain pipe, and the U-shaped pipe can be installed to prevent the air leakage, insects and rats from invading. U-tubes are not installed on the drain pipe, and sometimes the unit is corroded.